Article List
- Ship Launching and HaulingGeneral introduction of Ship launching with marine airbags. The traditional ship launching methods include end on launching , side launching and dry dock floating. Most airbag ship launching are end on launching.Tech News June 15, 2017
- Special Attentions During Use and Launching of The AirbagFirst, the airbag must be checked if the pressure gage is normal before being used.Tech News June 08, 2017
- Huge Cofferdam Launch SolutionAirbag launching technology is especially good for temporary launch project because of its low demand of launch conditions. Huge steel cofferdams are fabricated for bridge piers construction, some of them weigh a few thousands tonnes that is difficult for floating crane to lift and install.Tech News June 07, 2017
- Ship Launching Risks-Hold SystemLots of big or small ship launching accidents are caused by less attention to ship holding system that include ground anchor , winch, pulley, wire ropes and shackles. In the below case people employed a bulldozer to hold the ship, without suspense the bulldozer was launched into water with the ship.Tech News June 07, 2017
- Ship Launching Risks-Water LevelAirbag ship launching is flexible. It has tolerance for the water deficiency but that tolerance has limit surely. If ships are launched at deficient water, two phenomena may happen: when the stern drops abruptly, airbags may burst or launch ramp end collapse due to strike moment then vessel bottom...Tech News June 07, 2017
- Ship Launching Risks-RampNowadays ship launching with airbags is not a novelty. Estimated in China every years there are about 200 vessels have been launched with airbags. Airbag ship launching technology is simple and practical, it can save much money and time.Tech News June 06, 2017
- Dawson Marine Airbags VS SPMTsMarine airbags are often called ship launching airbags that indicates they are most used for launching ship into water. Inspired by ship launching, people developed many applications of marine airbags in different fields, the most remarkable one is heavy lifting and moving with marine airbags.Tech News June 06, 2017
- Fendering Systems DesignThe purpose of installing fenders on the pier is to protect the vessel and the pier from damage when the vessel berths alongside the pier. The fenders absorb the berthing energy of the vessel and soften the berthing impact on the pier.Tech News June 06, 2017
- Vessel Haul-Out with AirbagsUsing marine airbags to haul out vessels can overcome the limitations of instruments and slipways and make haul-out work easy. The haul capacity of this system is decided by the pull winch and slope angle of slipway or ramp so it is easy to get improved.Tech News June 06, 2017
- Move Caisson with Air BagsTo lift concrete blocks, generally airbags need higher pressure than lifting vessel up because vessels have bigger bottom/weight ratio. For big caisson lifting, air bags' pressure can reach 0.3 MPa. Moving caisson with marine airbags needs winches to provide pulling and restraint force.Tech News June 05, 2017