| Hook load binder to chain so you can operate it while standing on the ground. Position load binder so its handle can be pulled downward to tighten chain. Be aware of ice, snow, rain, oil, etc. that can affect your footing. Make certain your footing is secure. DAWSON recommends AGAINST the use of a handle extender or "cheater pipe". If sufficient leverage cannot be obtained using the lever type load binder by itself, a ratchet type binder should be used. If the above recommendation is disregarded and a cheater pipe is used, it must closely fit the handle and must slide down the handle until the handle projections are contacted. The pipe should be secured to the handle, for example, by a pin, so that the pipe cannot fly off the handle if you loose control and let go. The increased leverage, by using a cheater pipe, can cause deformation and failure of the chain and load binder. During and after tightening chain, check load binder handle position. Be sure it is in the locked position and that its bottom side touches the chain link. Chain tension may decrease due to load shifting during transport. To be sure the load binder remains in proper position: Secure handle to chain by wrapping the loose end of chain around the handle and the tight chain, or tie handle to chain with soft wire. When releasing load binder, remember there is a great deal of energy in the stretched chain. This will cause the load binder handle to move very quickly with great force when it unlatched. Move handle with caution. It may whip - Keep body clear. Never use a cheater pipe or handle extender to release handle. Use a steel bar and pry under the handle and stay out of the path of handle as it moves upward. If you release the handle by hand, use an open hand under the handle and push upward. Do not close your hand around the handle. Always keep yourself out of the path of the moving handle. Do not attempt to close or open the binder with more than one person. | 
English
